Hallo Forum,
die gerade vom Kumpel vorbeigebrachte USB-HDD (2TB groß) an meine DS207 angeschlossen zwecks Datenaustausch. Aber irgendwie hab ich probleme das Mopped ins rennen zu bekommen.
Also ich habe wie gesagt eine DS207+ mit DSM 2.0 und eine 2TB große USB-Platte dran die folgendes besagt:
Weiss wer wie ich herausbekommen kann um welche Dateisysteme es sich bei den Partionen handelt? Und was für Dateisysteme ich bei der DS207 einbinden kann? Möchte eigentlich auf der Linux Partition schreiben und lesen. Er bindet mir aber automatisch die NTFS Partition ein.
Gruß
die gerade vom Kumpel vorbeigebrachte USB-HDD (2TB groß) an meine DS207 angeschlossen zwecks Datenaustausch. Aber irgendwie hab ich probleme das Mopped ins rennen zu bekommen.
Also ich habe wie gesagt eine DS207+ mit DSM 2.0 und eine 2TB große USB-Platte dran die folgendes besagt:
Rich (BBCode):
Raid1_Station> fdisk -l /dev/sdl
Disk /dev/sdl: 2000.4 GB, 2000396746752 bytes
255 heads, 63 sectors/track, 243201 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x0003dc12
Device Boot Start End Blocks Id System
/dev/sdl1 * 191224 243201 417513285 7 HPFS/NTFS
/dev/sdl2 1 191223 1535996929 5 Extended
/dev/sdl5 1 190876 1533202432 83 Linux
/dev/sdl6 190876 191223 2793472 82 Linux swap / Solaris
Partition table entries are not in disk order
Raid1_Station> mount
/dev/root on / type ext3 (rw,data=ordered)
/tmp on /tmp type tmpfs (rw)
/sys on /sys type sysfs (rw)
/proc/bus/usb on /proc/bus/usb type usbfs (rw)
/dev/md2 on /volume1 type ext3 (usrquota,grpquota)
/volume1/opt on /opt type --bind (rw)
/ on /volume1/root type --bind (rw)
/volumeUSB2/usbshare on /volume1/video/Film/MobileDisk type --bind (rw)
/dev/sdm1 on /volumeUSB2 type ext3 (rw)
/dev/sdl1 on /volumeUSB1/usbshare type ntfs (rw,nls=utf8,fmask=000,dmask=000)
Raid1_Station> umount /dev/sdl1
Raid1_Station> mount -t ext3 /dev/sdl2 /volumeUSB1/usbshare
mount: wrong fs type, bad option, bad superblock on /dev/sdl2,
missing codepage or helper program, or other error
In some cases useful info is found in syslog - try
dmesg | tail or so
Raid1_Station>
Weiss wer wie ich herausbekommen kann um welche Dateisysteme es sich bei den Partionen handelt? Und was für Dateisysteme ich bei der DS207 einbinden kann? Möchte eigentlich auf der Linux Partition schreiben und lesen. Er bindet mir aber automatisch die NTFS Partition ein.
Gruß